Reemplazo de carcasa trasera de DulaShock 3

Escrito Por: Andrew Bookholt
  • Comentarios: 9
Reemplazo de carcasa trasera de DulaShock 3

Dificultad

Moderado

Pasos

3

Tiempo Requerido

2 - 5 minutos

Introducción

Usa esta guía para remover la carcasa trasera de un control DualShock 3.

  1. MnO4C2NgVBnH1meE

    • Remueve los cinco tornillos Phillips de 7.2 mm que aseguran la carcasa trasera a el control.

  2. lvGLlAtXpOWLih6R

    • Presiona en la carcasa trasera entre los sticks analógicos y ligeramente levanta el borde inferior del resto del controlador.

    Es ist nicht ganz eindeutig das zwischen den beiden Analog-Sticks gedrückt werden muss. Der gelbe Punkt fällt kaum auf. Ein Bild mit Daumen an dieser Stelle wäre gut oder soooo…

    Tom -

    it’s not very clear but for this step you need to push where the yellow dot is shown on the picture. it’s rather tough. you kind of have to move the whole back plate a bit for it to work.

    Brandon der Blatter -

    I’m stuck at this step because I can’t for the life of me undo the clip

    IttyBittyGamerVR -

  3. pteSAIrvQBgU3cdM
    pteSAIrvQBgU3cdM
    BnFWDEdOvNaFHOJa

    • Empuja la carcasa trasera ligeramente hacia el borde superior del control para despejar el panel frontal de los 2 gatillos.

    • Jala la carcasa trasera del control, ten cuidado de que los 2 gatillos no salgan disparados.

    • Si accidentalmente los gatillos salen disparados, tenemos una guía de gatillos para que los vuelvas a colocar.

    the "trigger button guide" link links back to this page :o

    Alexander McMahon -

    I accidentally popped a trigger off, and both L1 and R1, because I skimmed and didn't read this step. Fortunately it's not hard. The tricky part with the triggers is that there's a little spring on them. You have to press the side of the spring that's pointing away from the trigger against the sloped surface of the controller (look at the other trigger for reference, if you only popped one off). Then you just slide the trigger on until the "handlebar" bits near the center click into place.

    briancaraher -

    The reset button – a small mostly-rectangular rubberized piece – fell out as I removed the rear cover. It covers the hole near the middle screw and has a post that presses SW1 on the motherboard.

    Fletcher Stern -

Conclusión

Para reensamblar tu dispositivo, sigue estas instrucciones en orden inverso.

Autor

Andrew Bookholt

578639 Reputación

3 comentarios

i have a different dualshock 3 than yours. mine is built in a different way and has a different battery

MasterKlaus Produtions (Swe0b) -

Sony did that throughout the Dualshock 3’s production as they found out what would cause them to malfunction and fixed the issue. It should be alright as long as you are able to replace the battery when needed.

Aiodensghost -

iran:

نحوهی تعویض طلق دسته پلی سه هم بذارین. لطفان

مجید محمدی -