Reemplazo de la lente del láser de la PlayStation 3 Slim

Escrito Por: ZFix
  • Comentarios: 14
Reemplazo de la lente del láser de la PlayStation 3 Slim

Dificultad

Moderado

Pasos

6

Tiempo Requerido

45 minutos

Introducción

Video tutorial: cómo reemplazar solo la lente del láser:

  1. SjTZsMGJ4DG1Ijyn
    SjTZsMGJ4DG1Ijyn
    JWNrZHOwKMxsbxSE

    • En caso de estar presentes, quita la cinta adhesiva que sujetan los cables al lector Blu-ray.

    What does the white and black cable?

    Robert Brown -

  2. eqAyKhYjtWqUhqTJ

    • Utiliza la punta plana de un "spudger" o tus uñas para levantar la pestaña que retiene el cable plano en su conector.

    • Asegúrate de que estás haciendo palanca en la pestaña y NO en el conector en sí.

  3. lLTEEDyNQhUkXKsI

    • Tira del cable plano hacia arriba para desconectarlo.

  4. Wpqs1UUFQoUqnvIW

    • Tira hacia arriba del cable de alimentación del lector Blu-ray.

  5. FNNWVwaMWMQB2Wu4

    • Quita el tornillo Phillips de 9.5 mm que sujeta el lector Blu-ray a la carcasa inferior.

  6. rIJHTp3K2knmtHuc
    rIJHTp3K2knmtHuc
    uZnZAu15OX3iRnEQ

    • Levanta el lector Blu-ray ligeramente por su lado derecho para sacarlo de su hueco.

    • Quita el lector Blu-ray de la PS3.

    • Después de que vuelvas a instalar el lector Blu-ray, asegúrate de que la placa de control está correctamente colocada en la carcasa inferior antes de continuar con el procedimiento.

    • SI estás reemplazando el lector Blu-ray por uno nuevo: utiliza este video (ten en cuenta que está en inglés, pero es visualmente bastante descriptivo .

    my cd drive has 3 cables, two by the fan, one right under, i believe i damaged the one on the bottom because it is very difficult to put back in hence the repair. But the photos here dont show the 3 cables, not sure if you have one for this model?

    Eduardo Cutino -

    I followed the steps and I successfully removed my disc drive the guide was helpful but I had issues and the ribbon cables on my replacement disc drive were too short after a soddering attempt failed I now need to rebut a disc drive can someone direct me to a proper replacement with the correct size I need it's a ps3 slim 120G please help

    Nick -

    I popped a friends apart to see if I could put in mine, which won't stay online for more than 1minute 10 seconds. Plays DVDs fine. Anyway, his had 3 cables and mine only has 1. How do I know which DVD player to order?

    ntdoc -

    Completely different drive in my slim. 3 ribbon cables on the back that pull straight up out of their connectors. And one wide ribbon hidden underneath and almost impossible to get to. After disconnecting the 3 visible cables lift the back of the drive about 3/4" and use a plastic spudger to release the clip on the cable before lifting off the drive. Reinstalling is a nightmare. The cable has a black line to indicate how far to insert into the connector. Get it in there somehow then use the spudger to push the clip down. If it's not level release it and try again and again and again until you get it right. Sony must use some awfully small fingers when they build these ;-)

    jurquijo -

    I had the same issue with the ribon feeding beneath the blu ray player. This video provided a much better solution. It requires dissassembling the blu ray: https://youtu.be/Upy2bTev3M0

    Rebel Seven -

    My disk drive needs to be replaced. Your step by step is straight forward and are very helpful. At the end you mentioned “If replacing the Blu-ray drive with a new drive, swap the circuit board from your old drive into the new drive”.

    Which circuit board? Can your please add a picture of the circuit board you are referring to?

    Henry -

    @hh168 There’s now a link in the text of that step, which will take you to a video with detailed instructions for swapping the board.

    Jeff Suovanen -

    First I replaced the drive and it would load a disc and see that it was either a game and which game or a BluRay or DVD and which, but I got error codes when trying to play them.

    The codes seemed to be tamper coding, and swapping the board seemed to be a good idea.

    It went smoothly, but now discs will not feed into the drive.

    Please help.

    Zachary Mannes -

Conclusión

Para volver a armar tu dispositivo, sigue estas instrucciones en orden inverso.

Autor

ZFix

Miembro Desde 09/12/13

188324 Reputación

5 comentarios

Donde puedo comprar refacciones y partes para PS3 Slim?

David -

yo vendo amigo = ivaramso@gmail.com para ventas

Ivan Ramirez -

How can this be easy, but the Blu-Ray drive be considered Moderate? You need to complete the Blu-Ray drive removal prior to replacing the laser lens, which means this is at best a Moderate task.

Ben Kevan -

This is not lens replacement, this is drive replacement. Is there a separate guide for lens replacement?

cmchallam -

Shows how to do the laser assembly in the video but not how to reinstall it in the drive. Lazy guide. Just buy a whole new drive if you are following this guide.

Beninja -