Reemplazo del panel trasero de la consola Nintendo 2DS

Escrito Por: Fina Beauchamp
  • Comentarios: 10
Reemplazo del panel trasero de la consola Nintendo 2DS

Dificultad

Moderado

Pasos

3

Tiempo Requerido

No hay estimado

Introducción

Esta guía te enseña a remover el panel trasero del Nintendo 2DS. Esta guía demuestra como remover los tornillos que sujetan el panel trasero para poder tener acceso a las otras partes de la consola Nintendo 2DS.

  1. vkEjnCVvCfkcXpKn

    • Retira los diez tornillos Phillips que sostienen el panel posterior de la consola.

    Can't take off the screw top left next to the battery. What type of screwdriver do I use and where can I find some?

    Little Mac -

    I used a husky with changeable heads, you could probably find one on amazon

    Minecrafter Pig -

  2. ona5d6XElywnV2F6

    • El panel trasero está sujetado a la placa madre por un cable plano, así que ten cuidad de no levantar el panel trasero demasiado lejos del dispositivo.

    • Con cuidado, levanta el panel hacia arriba.

  3. nCtU5fTtc3gYBBVe

    • Con cuidado, da vuelta el panel trasero para localizar el cable plano.

    • Remueve los dos tornillos Phillips que sujetan el cable plano al panel trasero.

    • Remueve los gatillos izquierdo y derecho. Tiene bisagras que podrían romperse y resortes que podrían salirse.

    You can also detach the cable from the motherboard safely by flipping up the connector on the motherboard. Just don't forget to reattach. Some will find this tedious but may save time if you know what you're doing with said connectors.

    Blackbeard -

    I agree, this is what the guide i followed said to do and since I was disconnecting all the other ribbon cables it made perfect sense to do it that way.

    Lin -

    pay attention: my 2ds dropped it's lens covers at this step

    Jos van Reenen -

    Likewise, I used a tiny drop of glue to put the lens back in place. Take care not to dirty the lens.

    Elliot West -

    The picture you have there has the camera lens ribbon installed upside down. The ribbon needs to be pointing down when you re-attach it not up.

    Rick Parrish -

    Agreed, ribbon cable looks upside down in picture

    Elliot West -

Conclusión

Para volver a ensamblar tu dispositivo, sigue estas instrucciones en orden inverso.

Autor

Fina Beauchamp

Miembro Desde 12/01/15

2864 Reputación

2 comentarios

The two top screws on the backpanel I cannot get out, I used the same screwdriver I used for every other screw.

Please help!

Evergreen -

For those two screws that are on the top cap aren’t supposed to come out, if the do come out it means you’ve broken those screws. Also after unscrewing that top it should just slide up.

Leo Ochoa -